Tomorrow is the last day I have access to an extractor thingee for safe air when putting a two part coat on my PLA prints, so ~OF COURSE~ my prints have started failing.
It's either pillowing or under extraction, so I've cleaned the printing head, and the bowden tube and slowed the printing speed to match the PLA manufacturer's specs. The first several prints were fine, so no idea why the last two were all brittle and bad.
You've probably checked this, but if you use Cura, double check your printer settings.
Some people (including myself) have reported that a recent update has changed some printer settings back to default.
It set my filament thickness from 1.75 to 3.0 right before I did a long print.
The print looked good, but when I pulled it off the plate it crumbled in my fingers.
I was not happy.
@celesteh On Cura 4.0, the setting is under
Then select your printer from the list and click "manage printer".
Check both the printer settings and the extruder settings.
You probably set these when you got y our printer then forgot about them (I did!) but for some reason a recent update changed "Material Diameter" on my settings and screwed up my print.
Took me a while to figure it out.
@apLundell I had a few good prints before it had trouble in the latest batch, so this probably isn't the problem, but I'll give it a look. Thanks
The social network of the future: No ads, no corporate surveillance, ethical design, and decentralization! Own your data with Mastodon!